On 8/28/06, derf <derf247@gmail.com> wrote:
> Mo$$ and V$B both have little exploded diagrams available online.
> They are about as good as what you might find in most manuals. The
> wire hubs are different, but I think most other parts are the same.
> You looking for front or rear or both? Mo$$ has a little supplemental
> blurb in their catalogs about front bearings and their orientation.
> Cheers,
> Derf
Thanks, Peter & Derf. I saw the Mo$$ diagram but was hoping for
something a bit mroe instructive for the novice. Guess I can figure it
out though. One front bearing is a little loose but not knowing the
state of the others, I figured on just going through and replacing
them all unless they are made of platinum or something. Now it sounds
as if there is a tapered roller bearing replacement for this
application. Does anyone have the bearing numbers and/or a set of
instructions for this mod?
Cheers!!
Jim
|