Phil -
The two fly wheels I removed on Wednesday I just used a little prybar that
WST had. I just pried incrementally all around so I didn't booger anthing
up, but loosened them just slightly so eventually they just fell off
(actually they didn't fall off cause I had my other hand under them).
Bud
PS As far as they crank pulley nut, WST had the right size on it so we could
torque the flywheel bolts, but I don't remember what it is. Measuring would
be the best thing, then pick one up at Sears or somepollace like that.
----- Original Message -----
From: "Phil Nase" <nase@ptd.net>
To: <Spridgets@autox.team.net>
Sent: Sunday, August 27, 2006 12:14 PM
Subject: Flywheel removal
> Engine is out, clutch removed and the flywheel bolts off. I can't budge
the
> flywheel loose. What can I do to remove it without boogering something
up?
>
> Anyone know off hand what size the crank pulley nut is? I have to have
> something to hold it when installing the new flywheel and torqueing the
> bolts. I have a 1 3/16 socket and its bigger than that.
>
> Phil Nase
|