Thanks Frank!
Lester
On Jul 3, 2006, at 8:21 PM, Frank Clarici wrote:
> Lester Ewing wrote:
>
>> Ok,
>> so I went out to set the timing.. I need to advance it just a
>> tad BUT the vacuum advance unit is hitting the oil tube and as
>> such no way to advance any more...
>
> You have to move the drive gear.
> Remove the dizzy, note where the rotor is pointing.
> Remove the dizzy clamp (2 bolts)
> Under the clamp is a collar, there is a bolt on one side of the
> collar, remove that bolt, the collar should twist out with a slight
> tug.
> I have had them where I needed to pry them out with levers but it
> comes out.
> Look in the hole, you will see the dizzy drive, note where the slot
> is pointing.
> Using a long 5/16 fine thread bolt, screw it into the center of the
> drive gear, twist and pull out at the same time and the gear comes
> out.
> It's a bit tricky as it is disengaging from the came gear.
> Move it back a bit and twist and push it back in. It needs NO
> FORCE, it will drop right in and engage the cam gear. NO BFH on
> this job ;)
> Note the new position of the slots on the drive gear, sometimes it
> goes back in the same teeth as it rotates down and in.
> If it moved back a tad, put it all back together and set the timing.
>
>
> --
> Frank Clarici
> Toms River, NJ
|