| To: | Kid Vid <kidjoevid@yahoo.com> |
|---|---|
| Subject: | Re: master cyl bore |
| Date: | Sun, 06 Mar 2005 21:21:29 -0500 |
| Cc: | spridgets@autox.team.net |
| References: | <20050307015014.34509.qmail@web90107.mail.scd.yahoo.com> |
| User-agent: | Mozilla/5.0 (Windows; U; Windows NT 5.0; en-US; rv:1.4) Gecko/20030624 Netscape/7.1 (ax) |
Kid Vid wrote: > Hmmm...my sprite is a seemingly very original 62 > HAN6L, 948. But the master cyl bore is positively > 3/4". Drums all around, no apparent mods. So I'm going > to order a rebuild kit from M*** for a 7/8" master cyl > - any obvious problems here? Maybe your HAN6 is the very last one and BMC ran out of 7/8 bore masters. Knowing the HAN7s were to have a 3/4 bore master they just started a bit early on your Sprite ;) Not that BMC was known to do anything like this on any other, or should I say ALL other marques. -- Frank Clarici Toms River, NJ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Fw: failure notice, Unknown |
|---|---|
| Next by Date: | Re: Master cyl bore, Unknown |
| Previous by Thread: | Master cyl bore, Unknown |
| Next by Thread: | Re: Master cyl bore, Unknown |
| Indexes: | [Date] [Thread] [Top] [All Lists] |