i NOW use a 45 degree angled carbide bit. chuck it up in the drill and you
are in production mode camfering threaded holes! be carefull with drill
bits! cast iron is far softer and easier to drill into than you might
suspect!
chuck.
been there .... removed some threads!
-----Original Message-----
From Glen Byrns <grbyrns at ucdavis.edu>
To: spridgets@autox.team.net <spridgets@autox.team.net>
Date: Wednesday, October 29, 2003 6:41 PM
Subject: Re: Head Gasket
>A larger drill bit worked well for me. Where did you get the thicker
copper
>gasket?
|