daniel,
a question about the pulley itself. is it a stamped tin pulley or isit a
machined casting type? i could be interested in a pulley or two but! would
like to know it's material make up before considering making a request.
chuck
-----Original Message-----
From Frank Clarici <spritenut at Exit109.com>
To: Daniel1312@aol.com <Daniel1312@aol.com>
Cc: spridgets@autox.team.net <spridgets@autox.team.net>
Date: Sunday, October 26, 2003 10:29 PM
Subject: Re: Water pumps and pulleys
>Daniel1312@aol.com wrote:
>
>> However, it occurrs to me that I am not 100% certain that this fact
stands
>> true for the small or standard impellor depth water pump (9.5mm) part
number
>> GWP132. It is true for the deep impellor pump (13.5mm) part number GWP
134.
>
>> So, any feedback now or at any time in the future most welcome.
>
>Daniel
>
>I have a shallow impellor water pump and one of your large w/p pulleys.
>(thanks)
>I have to run the shallow impellor on my 12cc thin wall block.
|