Dunno about the bearing factor... but its being touted as an aircraft &
marine engine, which would mean it needs to have a pretty stout duty
cycle...
-----Original Message-----
From owner-spridgets at autox.team.net
[mailto:owner-spridgets@autox.team.net]On Behalf Of Daniel1312@aol.com
Sent: Tuesday, October 07, 2003 3:04 PM
To: wsthompson@thicko.com; spridgets@autox.team.net;
team-thicko@autox.team.net
Subject: Re: pretty impressive
With an all roller bearing design I bet the time between re-builds is pretty
short. I have seen a lot of revolutionary engines that get built but then
little more is heard of them. The orbital 2 stroke was around a long time
and
Ford UK even had some engines in some cars. I think the engine wasn't that
revolutionary but the injection system was.
Cosworth bought out some company making a very cleared stepped piston type
engine that seemed very promising but I have no more of it for some years
now.
Daniel1312
In a message dated 07/10/03 10:48:41 Pacific Daylight Time,
wsthompson@thicko.com writes:
|