Hi all,
I have 4 degree tapered shims under the springs with Winner's Circle 10
leaf springs and I'm real happy with the ride hieght, it sits level at
rest. It sat about 1-2 inches too high before. I found them at
Summitracing.com from Lakewood, but I had to do a little cutting for the
narrower width of the springs. They list them as part #LAK-20510. This
is drag racer stuff, so it's good and strong. I have a couple digitals
if you want to email me I'll send 'em over.
Dave & Bobbie
Charles Christ wrote:
>you need to use rear wheel drive axle degree shims (to be inserted between
>spring and spring mount) to effectivly lower a 1/4 eliptic rear equipped
>cars. this is alignment shop / spring specialty stuff. the shims are
>something most garages are completly unaware of! the shims are used to
|