could brad make use of the +20 bearings? or would he need a larger
oversize? Brad, how much bigger do you think you'll need?
Original Message:
-----------------
From Kevin Valentine valntine at ptd.net
Date: Tue, 05 Aug 2003 10:36:43 -0400
To: macy@bbl.med.upenn.edu, toyman@digitex.net, spridgets@autox.team.net
Subject: Re: Oversize Cam Bearings
Brad,
Larry is correct. Oversize cam bearings are (or were) available
(Vanderville).
I installed a set of cam bearings in a block about 2 years ago. They
cam out of a box that was marked (STD), but the cam wouldn't go into
the block.
On the shelf next to where I had stored the "STD" bearings I found the
problem. A box marked "+20" and in that box were a set of "STD" cam
bearings..........
Kevin V.
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|