GOOD POINT. I have a pre-engaged starter but retain the cup cover. I figure
if I fabricate a flat cover I can save a little weight and have a neater
installation.
Thanks
Daniel1312
In a message dated 28/05/03 18:34:19 GMT Daylight Time, jamesa@HI-TORQUE.com
writes:
> with a
> gear-reduction type, which comes at the ring gear from the opposite side, so
> the original "cupped" starter pinion gear cover isn't really necessary; a
> flat plate would do - except I'm too lazy to make one. Anybody out there
> have a spare pinion cover they'd like to sell?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|