Tom,
When I had my block gone over at the local machine shop, he told me "no,
sweat, these are a standard size." and he replaced them with the
off-the-shelf ones he had for American motors. they were the shallow cup
type you describe and have been for 2 years.
Glen
> List:
> We are getting ready to put together our #2 race motor, "Mellow
> Yellow " Got the block back from the machine shop and immediately
> noticed that I forgot to get new freeze plugs. I need the kind that are
> shallow cups (! 5/16 ") for the back of the motor. On the side we used
> to use a copper freeze plug (also 1 5/16") that tapped into the hole and
> was tightened in by turning a nut in the center. I'm not having any luck
> with the locals. Does anyone out there know what I'm talking about and
> better, where to go to get them.
>
> Regards,
>
> Tom Speed
> www.mgracer.com
> Charlotte, NC
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|