> I'm trying to replace the A-arms with a rebuilt pair. I've gotten
everything
> torn down just fine. The problem now is the pins that hold the A-arm to
the
> frame. They won't budge. I've beaten them, pried, soaked with penetrant,
> etc. No luck. Any suggestions on removing them? I'm discouraged.
What has made the difference for me on getting these off is heat. Heating
the ends of the bolts up with a propane torch seems to break the rust free
and allow them to be driven out without beating up the brackets on the frame
too much. I recommend doing this in a well ventilated place-the rubber
bushings make a lot of very bad smelling smoke.
Bert
3 Midgets and 2 Sprites, and none on the road (but one's pretty close)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|