Yikes! I see in Haynes it does say 20 lbs ft.
Bentley DOES show it. It is 6 lbs.ft.
When using the Bentley factory manual specifications, go first to the
engine you have, then if not shown, go back to the prior engine, in this
case 1098cc where it is shown. Bentley only shows what has changed from the
previous model. I hope that's clear.
Good luck.
Peter C
===
At 09:20 AM 11/26/2002, you wrote:
>Anyway put the pan back on last night. Kind of an aggravation, actually.
>Haynes said to tourque to 20 lb-ft. Nothing in Bentley. So I went with
>Haynes. Had a new "fitting kit" from Moss (bolts, lock, and oval washers)
>and they would not take 20 lbs. One broke (able to get it out) and the
>others stretched like mad. OK, back to the old bolts. They were better,
>but a few of those stretched too, so I stopped wrenching them. Probably
>about 15-17 lbs on them. So is Haynes wrong? Or do I just have crappy bolts?
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|