Gerard wrote:
> >Back off throttle IDLE screws with
> >"interconnect" loosened clear of their
> >carb. "platforms".
>
> Sorry Bob,
> The problems with these carbs are not balance, but probably unequal spring
> pressure. These are the ones I was struggling with a few months ago. I
> finalyy got it to run nearly right,
That was what I found with Bill Loeb's carbs. One correct spring, the other
unidentified. It calls for springs that are 2 1/2 Oz. at 2 5/8" inch as I
recall. Found one in a used carb at hand. However, on close inspection with a
loupe, found that one needle was worn from dragging on the jet. So the new
spring was a temp. fix. Worked a lot better, but these carbs are bound for a
complete rebuild soon, throttle shafts included.
Paul A
>
>
> Gerard
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|