Larry,
I don't know if anyone has answered your steering wheel question - a stock
Bugeye steering wheel is 16" in diameter.
Rick
'59 Sprite
> ----- Original Message -----
> From: "Larry Pitts" <FUZZY95687@yahoo.com>
> To: "Gerard" <pixelsmith@gerardsgarage.com>; <spridgets@autox.team.net>
> Sent: Tuesday, September 17, 2002 12:46 PM
> Subject: RE: Acouple of questions
>
>
> > Gerard,
> > Yes, I'm refering to a blanking plate. Good picture of
> > Jim's blanking plate, thanks.
> > My 1275 will not be that radical. It cleaned up at
> > .060 over and I'll be running a Kent 266, nothing
> > special with the head and carburation is as of yet
> > undetermined. I'm still trying to decide among the
> > DCOE 45( need a manifold), standard HS2's( need a
> > rebuild) or a pair of HIF 4's(need a manifold).
> > The fuel pump pad is not drilled, I'm just trying to
> > think ahead (like 6 months or so).
> >
> > So, no problem about drilling and tapping the block
> > without a blanking plate?
> >
> > 14 or 15" steering wheel replacement?
> >
> > Any one know the size and thread of the oil pressure
> > oulet on a 1275 block?
> > Has anyone on the list installed a fuel pump cutoff
> > switch??
> > Larry Pitts
> > 60Bug
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|