Listers
I had the engine out of my 1098 sprite for some repairs. I put a new clutch
disc and throw out being in for good measure.
I bled the slave, the pedal goes halfway to the floor and then stops.
I have tried some adjustments at the master cylinder with out much luck.
My thought is, maybe the clutch disc is binding on the spines of the input
shaft??
Any ideas
Thanks
Greg Higgins
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|