In a message dated 5/30/02 11:28:21 PM Eastern Daylight Time,
w.gilroy@verizon.net writes:
> Any thought on what is a well designed heat shield?
I would think that polishing the under side of the shield, or covering the
asbestos or other insulator with a polished or shiny surface underneath would
help a little by reflecting some of the heat away from the carbs. No
engineer here, but as I remember my old Physics class transfer of heat
principles, there is conductive, convective, and reflective. The shiny side
seems like it would attack the reflective transfer.
Gawd I sound techy, don't I?
--David C.
(Once again flying by the seat of his pants) 8^)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|