Anyone changed their rear hub bearings recently?
I changed one last night (I was in there curing an axle leak, so I
figured I may as well change the bearing as well, even though the
existing one seemed OK), and the new bearing has noticeably more play in
it that the one I removed! Before the half shaft is slid back in, I can
wiggle the hub. With the half shaft in, it feels much better, but
should it be that sloppy in the first place?
The kit I used was from Moss. Did I get a junky bearing that I'd be
better off not using?
I have a kit for the other side too, and it appears to be just as
sloppy. Haven't fitted it yet, and wondering whether I should!
Phil
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|