In a message dated 3/18/02 9:50:18 AM Eastern Standard Time, dmeadow@juno.com
writes:
> The clutch is notoriously difficult
> to bleed since the clutch hose comes up at an angle away from the clutch
> master cylinder.
Somewhere, maybe on here, I saw a method of replacing the bleeder screw with
a fitting that connected to a piece of tubing which was run up to the engine
bay, then a bleeder screw was put into the piece of tubing. By doing that,
it was possible to bleed the clutch under the bonnet.
--David C.
|