Hi all,
I'm working on 60 Bugeye that I didn't disassemble. Boy am I going to
have questions for you. First, I need to know the roouting for the
brake line from the front to the rear. I had the old lines but they were
bent up a little. I assume the line runs under the floor on the pass.
side of the trans tunnel. Does it go outboard or inboard of the channel
brace that is welded under there? Which clips hold the line and how many
how far apart? the new floor doesn't have any holes and the old one was
gone. I also know the fuel line crosses under along the cross member,
then follows the frame rail. Does it run parralel to the brake line, how
far apart clips, I know it comes up and over the rear, it's just the
under floor area I'm stumped. I have some parts in a box that I don't
know if they even belong on a Bugeye. Any help is going to be
tremendously appreciated.
Thanks
Dave
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|