Jon,
Personally never seen one without a groove. Any chance it was cleverly
concealed by a snug fitting paper gasket?
Gerard
At 9:18 AM -0800 2/21/02, Jon Paschke wrote:
>Hi
>Well I determined I needed a different hub as the bearing was slipping. I
>dug through parts and found a serviceable one and installed a new bearing
>and seal. Everything installed perfectly until I got to the O ring. In this
>hub there is no groove for it. Is this an early hub? Was this used somewhere
>else and no O ring specked? I proceeded with no O ring and now I hope it
>won't leak.
>Jon
>73 Midget
>
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|