> -----Original Message-----
> From: Paul A. Asgeirsson [SMTP:Pasgeirsson@worldnet.att.net]
> Sent: Friday, February 01, 2002 12:20 PM
> To: John.Deikis@med.va.gov
> Cc: Spridgets@autox.team.net; Spridgets-mod@autox.team.net
> Subject: Re: SPRIDGET CONTENT!!! SPRIDGET CONTENT!!!
>
>
> Why did you need to hone them?
>
Paul:
The bearings I got from one of the usual suspects were the "old
style" split bearings.
They are not really sized after installation because they flex when
they are pressed in.
They needed to be honed out to accommodate the cam. Front journal
wouldn't go in at all,
rear journal had a tight spot that I scraped and then finish honed.
Center one seemed
just right.
--JohnD
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|