I m looking for advice on which type of bolts and screws I have on my car.
I have a set of metric and standard tools, and I seem to alternate between
them all the time, though the bolts that I think are original seem to be
best fit by the metrics.
I need to clean out several bolts after painting, powder coating, etc. but
I9m not sure how to choose the correct taps or die for the job. I d prefer
to not trash any welded bolts by being more stupid than usual. At this
point I don9t have a t/d set so any advice on what I should purchase and how
to determine which to use would be appreciated.
Thanks again,
Mike Gagne
74 midget
|