I installed mine with the header already in place
bolted to the head. That held the manifold gasket in
place. Then, I did some precise measuring and put
centerline marks on both the manifold and intake
manifold gasket. I also worked out a horizontal mark
(located on the gasket aligning the top tangent of
each of the intake ports) from centerlines to set the
up and down placement.
John Holliday
--- Gerard Chateauvieux <pixelsmith@gerardsgarage.com>
wrote:
> John,
>
> I have a set of 1-1/2 inchers, but the manifold does
> not have the alignment
> rings like you normally find on the samller ones.
> What did you do to set
> yours up?
>
> Thanks,
>
> Gerard
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
|