Gerard Chateauvieux wrote:
> No discrepancy... We came up with the same number (that amazed me!). I
> measured from the rolled lip below the grille, directly in front of the
> hole. Since you covered the measuremnt from the rear edge, all bases are
> covered. I used the front because the rear one is so close I figured there
> might be more room for error, but mine is the same. Hvving all four is good.
>
> Gerard
>
> At 2:14 PM -0400 8/3/01, Ankitterer@aol.com wrote:
> >In a message dated 8/3/01 4:18:45 AM, bugide@solve.net writes:
> >
> ><< Ankitterer@aol.com wrote:
> >
> >> Larry:
> >>
> >> We make it 3/16" off the bottom edge, centered. They are 16-3/4" W by
> >3-5/8"
> >> H at least on our car.
Thanks to you both!! I was a little confused (not an unusual event) for a
while,
too. I'm off w/ my drill bits to make some new holes. Thanks, again.
--
Larry Dickstein
Lone Jack, MO
Pop. 420
|