Re: 1275 questions: Stock pistons with a Judson? Cylinder sleeves?

--- WEricars@aol.com wrote:
> The head work can be done by a good novice if you
> have the right tools, books 
> and templates and will then add cheap performance.

Here's a good site for DIY head work - note the
section on cutting the valve shrouds.  Vizard talks
about this in his book, and, I believe, gives geometry
as well:

http://home.hiwaay.net/~langford/corvair/valvejob.html
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/