Well, the adapter does fit the new MC too!!! I got a few things tightened
up, with a (very) few left to go.
I've been pumping fluid in to the system tonight. ... about 1500ml so far
... a fair amount of air is coming out and superfluous(sp) fluid also. In
the morning, I'll try the car's hydraulic fluid.
Robert D.
( I'm going to drive tomorrow morning. <fingers crossed> )
-----Original Message-----
From Robert Duquette <RobertDuquette at Sympatico.ca>
>Thank you Frank and ED,
>
>It does in fact, screw off. Does it fit the new MC? Stay tuned for
another
>exciting episode.
>
>Now I've gotta screw off to work. ( feeling much more positive about being
>on the road on Saturday morn. )
>
>Robert D.
>
>
>-----Original Message-----
>From: Frank Clarici <spritenut@exit109.com>
>
>>Robert Duquette wrote:
>>>
>>> I just attempted to install my new clutch MC. Bench bled real nice.
>Bolted
>>> right in without dropping the nuts more than twice. Go to connect the
>pipe
>>> to it and voila, a non-fit. The fastener on the pipe is too big for the
>MC
>>> opening.
>>
>>It unscrews, this fitting is for the larger (later) lines, early lines
>>should screw right into the casting without the adaptor.
>>3/16" pipe - 1/4" pipe
>>
>>--
>>
>>Frank Clarici
>>Toms River, NJ
>>Lots of Sprites
>>http://www.exit109.com/~spritenut
|