Hello spridgets,
ok.. i finally got around to trying to adjust my tach.. taking l
loop off the back didn't do it, so ooo ooo... following instructions
from fellow listers.. i took it out of the case to get at the
adjusting pot.. drilled the little hole so i could make adjustments
"on the fly"... everything hunky dorey.. until i noticed that a
little carbon disk.. (a resistor i believe) was laying on the
table.. broken.. i have superglued it back in, but an unsure if that
was the proper method of repair.. guess the upshot of all this is..
i could use a new tach?.... the old one wasn't working anyway.. so
nothing really lost.. but.. if anyone knows where to obtain a tach..
(or has a spare they could part with)... help me?!..
66 sprite...
--
Best regards,
Bill mailto:pythias@pacifier.com
|