"William M. Gilroy" wrote:
>
> You get the idea. I made my midget a roller yesterday
> and tonight while filling the tire I noticed it seemed
> to be sitting low in the rear. I had just removed and
Some of the questions people asked.
Q1. Is the engine installed?
A1. Everything is installed except the bonnet.
Q2. Did I tighten the fasteners while in the air or on the ground.
A2. I have not done the final tightening yet, so when it happens it will be
on the ground.
Q3. 1/4 or semi elliptical springs?
A3. semi elliptical springs.
Maybe it was always that low, not sure. Maybe the springs
are just worn out.
Here is what is installed.
New shocks and bushings and rubber bits. Old springs.
I guess I will not worry unless it cause a problem with bottoming out.
Then I will get new springs and look all jacked up :-)
Thanks again,
Bill Gilroy
|