The spacers are used to hold the wheel away from the hub a bit as the
center hole of the Vega wheels are slightly too small to go all the way
over the hubs. A better way is to open up the centers on a lathe ot
milling machine so it will go on over the hub properly. There is a lot
of outset on these wheels.
Paul
PAsgeirsson@juno.com
On Wed, 17 Nov 1999 22:27:58 -0800 "Dave Franks" <franks@teleport.com>
writes:
>Anyone have any experience putting Chevy Vega wheels on a square nose?
>I've
>been told that they might need spacers on the back but what about the
>front?
>I know the stud spacing is correct and I have replaced the stock 3/8"
>studs
>with 7/16"
>--
>Dave Franks
>franks@teleport.com
>67 AH Sprite MkIV
|