| To: | dms@snip.net, Dmrams@aol.com |
|---|---|
| Subject: | Re: Rotten floor |
| From: | Lancer7676@aol.com |
| Date: | Tue, 16 Nov 1999 22:35:54 EST |
| Cc: | spridgets@autox.team.net |
| Reply-to: | Lancer7676@aol.com |
| Sender: | owner-spridgets@autox.team.net |
In a message dated 11/16/99 10:33:39 PM Eastern Standard Time, dms@snip.net writes: << I was wondering if there is a good way of detaching the welds on the side rails or sills without causing too much damage? >> Yes there is, Michael. I did so by first drilling out the spot welds, then separating them with an air hammer chisel, then grinding the inner rocker smooth. It worked pretty well. --David C. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Rotten floor, D. Michael Scott |
|---|---|
| Next by Date: | Re: bonnet numbers, Frank Clarici |
| Previous by Thread: | Re: Rotten floor, Robert Duquette |
| Next by Thread: | Re: Rotten floor, Paul A Asgeirsson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |