| Subject: | RE: Muffler Customizing |
|---|---|
| From: | Ulix Goettsch <ulix@u.washington.edu> |
| Date: | Mon, 15 Nov 1999 12:26:13 -0800 (PST) |
| Cc: | Spridgets@autox.team.net |
| In-reply-to: | <51D0DFC32994D1118C7C00104B22E3FD042FF393@b2exch02.readrite.com> |
| Reply-to: | Ulix Goettsch <ulix@u.washington.edu> |
| Sender: | owner-spridgets@autox.team.net |
> IMHO... if you're worried only about restriction the best setup is to hang a
> glass pack type muffler right under the driver (at unfortunately the lowest
> point under our LBCs) and then dump it out on the driver side just in front
> of the rear wheel.
>
> -Drew
For a race application that is what is often done. But for a street car,
the right length of exhaust pipe adds torque.
I read in a Mini magazine that even the reduced length of a center exit
vs. a side exit exhaust on a Mini results in a loss of power.
Hard to believe.
Ulix __/__,__ ___/__|__
..............................................(_o____o_)....<_O_____O_/...
http://students.washington.edu/~ulix/ '67 Sprite '74 X1/9
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: DMV Non-Op, BILL |
|---|---|
| Next by Date: | Bugeye Top Bow, Larry Miller |
| Previous by Thread: | RE: Muffler Customizing, Andrew.Griffith |
| Next by Thread: | Re: Muffler Customizing, Lancer7676 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |