spridgets
[Top] [All Lists]

Re: Speedo calibration question

To: "Frank Clarici" <spritenut@Exit109.com>, "Spridget List" <spridgets@autox.team.net>
Subject: Re: Speedo calibration question
From: "Larry & Sandi Miller" <millerls@ado13.com>
Date: Thu, 11 Nov 1999 18:23:11 -0800
References: <382B6C7E.9FC8B19A@exit109.com>
Reply-to: "Larry & Sandi Miller" <millerls@ado13.com>
Sender: owner-spridgets@autox.team.net
52 feet 9 and 1/2 inches.

Larry Miller

----- Original Message -----
From: Frank Clarici <spritenut@Exit109.com>
To: Spridget List <spridgets@autox.team.net>
Sent: Thursday, November 11, 1999 5:25 PM
Subject: Speedo calibration question


> Do any of you listers know the correct number of feet to roll a car for
> the speedo calibration results to send Nisonger?
> This past summer while attending a wedding for a friends daughter, I was
> seated next to the Nisonger rep (small world) He did explain how to roll
> the car 54 feet, ???inches and count the tire revolutions. This I can do
> but I forgot the numer of inches.
> I have to send out the speedo on the A40 since it reads 70+ mph when
> it's only going about 30. The speedo has been "funky" the last few
> months according to my daughter but I recently replaced the speedo cable
> (thanks Peter) and tested it only to see it is stuck at 35 MPH when
> stopped and goes up from ther as soon as you start rolling. But it pins
> out at 80 on the hiway ;)
> With Toyota 5 speed, a Sprite 3.9 rear and bigger tires, I just want to
> have a speedo rebuilt to what I have.
>
> TIA
> --
>  Frank
>  Drive it or give it to somebody that will
>  http://www.exit109.com/~spritenut/
>



<Prev in Thread] Current Thread [Next in Thread>