| To: | Valentine <valntine@ptd.net> |
|---|---|
| Subject: | Re: Electrolytic cleaning of metal |
| From: | Frank Clarici <spritenut@Exit109.com> |
| Date: | Mon, 18 Oct 1999 08:53:45 -0400 |
| Cc: | Wiedemeyer <boxweed@thebest.net>, spridgets list <spridgets@autox.team.net> |
| Organization: | Positive Earth Drivers Club |
| References: | <00e801bf18b6$cb0cee40$467b503f@default> <380A87F1.6004@ptd.net> |
| Reply-to: | Frank Clarici <spritenut@Exit109.com> |
| Sender: | owner-spridgets@autox.team.net |
Valentine wrote: > > Bob, > > The neg. wire ALWAYS goes to the part being cleaned!! If you reverse > the polarity the part will be disolved! > > I know several people who have accomplished "part disolution" by > conecting the pos. to the part. (right Frank?!) > > Repeat after me.....Neg to part, Neg to part, Neg to part.......... > > Kevin Kevin is absolutly right. He made me write this on the blackboard 100 times. Negative to part...negative to part... -- Frank Drive it or give it to somebody that will http://www.exit109.com/~spritenut/ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | SU Baseline Settings, '74 Midget, richard.arnold |
|---|---|
| Next by Date: | Re: Removing needle-bearing pilot bush, Frank Clarici |
| Previous by Thread: | Re: Electrolytic cleaning of metal, Valentine |
| Next by Thread: | RE: Electrolytic cleaning of metal, Greg Gowins |
| Indexes: | [Date] [Thread] [Top] [All Lists] |