Source for 73.5mm pistons?

["Onstott, Curtis" <curt.onstott@orst.edu>]

I'm about to rebuild the engine on my '70 Midget.  I have also obtained a
Datsun 210 tranny that I will be installing at the same time.
I'm wondering whether I should bore it out and install 73.5mm pistons.  Is
this advisable for a daily driver?  I'm also going to do a little bit of
porting on the cylinder head.  I've got the Vizard book, but I'd like to
hear what the opinion of the list is on this matter.  Does anybody know of a
good place to pick up a set of 73.5mm pistons?


Curt Onstott - Crop and Soil Science Computing Admin 
  Oregon State University. - (541) 737-5875 - Office: CrpS 153b
                    http://www.css.orst.edu/curt
<http://www.css.orst.edu/curt> 
No, life IS a contest.  Perhaps it doesn't FEEL like a contest to YOU
                because I WON so long ago.  -Voorhis
  '70 MG Midget    '75 Jaguar XJ6     '95 Specialized RockHopper