| To: | ulix@u.washington.edu, dwramsey@worldnet.att.net |
|---|---|
| Subject: | Re: LBC clunker(driveshaft bolts)Now wire wheel welding |
| From: | RBHouston@aol.com |
| Date: | Fri, 2 Jul 1999 20:35:38 EDT |
| Cc: | spritenut@Exit109.com, spridgets@autox.team.net |
| Reply-to: | RBHouston@aol.com |
| Sender: | owner-spridgets@autox.team.net |
In a message dated 7/2/99 11:40:15 AM Mountain Daylight Time, ulix@u.washington.edu writes: > Next you'll weld > the wire wheels to the hubs... > > Ulix (X1/9 with recently installed SAE header-to-exhaust bolts) Does this help? Does it have to be MIG welded, or will JB Weld work? Robert Houston |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Porter book, Ulix Goettsch |
|---|---|
| Next by Date: | Re: Porter book, Ron Soave |
| Previous by Thread: | Bugeyes FS, Ron Soave |
| Next by Thread: | Rear Spring recomendation, AHSprite78 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |