Re: rear hub pulling question

[Ulix Goettsch <ulix@u.washington.edu>]

A big washer that fits right on teh axle tube.  The center bolt then sits
in the hole in the middle of the washer.
The inner bolts on the front A-arms have big washers on them with a little
arm on them.  If you cut the arm off, this washer is perfect!

Ulix


On Fri, 4 Jun 1999, Evangelos G. Makris wrote:

> I am trying to remove the rear hubs on a Sprite with solid wheels.
> 
> Could you please tell me what the central bolt of the "generic
> hub puller" should lever against? Is this a "special" tool or
> is there some practical and easy way around it?
> 
> After all, there is only fresh air at the centre of the hub...
> 
> Thank you
> Evangelos
> 

    Ulix                                       __/__,__      ___/__|__  
..............................................(_o____o_)....<_O_____O_/...
                                              '67 Sprite     '74 X1/9