| To: | Rick/Carolyn <walters@mail.softcom.net> |
|---|---|
| Subject: | Re: What to do first... |
| From: | Frank Clarici <spritenut@Exit109.com> |
| Date: | Sun, 09 May 1999 23:03:37 -0400 |
| Cc: | "J. Adrian Barnes" <adrian@icx.net>, Spridgets <spridgets@autox.team.net> |
| Organization: | Positive Earth Drivers Club |
| References: | <37360034.993F04CC@icx.net> <37364A90.7F40@mail.softcom.net> |
| Reply-to: | Frank Clarici <spritenut@Exit109.com> |
| Sender: | owner-spridgets@autox.team.net |
Rick/Carolyn wrote: > > Hi Adrian, > > Start with the body, Paint, then Mechanicals. Make sure you install the > wiper system before you install the dash. It can be done later, but > it's a real choice word job. Next the wiring harness is easier to > install without the dash. Assemble the dash on the bench then install. > Engine next, windscreen last just in case you slip while installing the > engine. Exactly! Windscreen last and don't forget the washer nozzles and tonneau snap before the dash goes in. -- Frank Clarici Toms River, NJ Bugeye Sprite 67 Sprite 59 A40 http://www.exit109.com/~spritenut/ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Octane, etc., andy webster |
|---|---|
| Next by Date: | speaking of fuel...., Toby Atwater |
| Previous by Thread: | Re: What to do first..., Rick/Carolyn |
| Next by Thread: | Re: What to do first..., Mike Maclean |
| Indexes: | [Date] [Thread] [Top] [All Lists] |