Thanks to all who replied with suggestions on top installations. I started
today by removing the old top and the front cross bow came off in my hand!
@$#%^&&!@()%. Durn. It parted at the pivot point of the connector it is
attached to, that is about half way down the connector. I'm sure you know
where I mean if you've done a top, because both sides are broken on mine and
I'm sure that means that all you guys with years experience have seen this
before. Can this be welded?? I'm not a bad gas welder, but I would never
try any welding here as it is right on the pivot; but maybe a real welder
could do it. Anyone tried this?? And if welding is not a possibility, am
I looking at a whole new frame?? I'm also missing one lousy Tenax stud;
anyone have a spare? Thanks for any help.
Geoff Branch '74 Meejut
|