Lancer,
The paint won't wrinkle unless you put it on thick. You have probably been
putting it on too thin in the areas where it's not wrinkling.
Bob
----------
> From: Lancer7676@aol.com
> To: sjonston@dreamscape.com; spridgets@autox.team.net
> Subject: Re: Painting dash and RE: Sprite Tuning Video
> Date: Friday, April 02, 1999 4:28 PM
>
> In a message dated 4/2/99 1:26:47 PM EST, sjonston@dreamscape.com writes:
>
> << How much of a pain in the rear is it to remove and paint the metal
dash
> from
> a 66 Sprite? >>
>
> Scott:
>
> I removed my '67 Sprite dash--didn't seem to be that difficult--lots of
small
> nuts involved. But painting it in the original Krinkle finish has proven
to
> be a pain in the arse. I have gotten how-to's and suggestions, followed
the
> directions on the can and still end up with some of it looking perfect
and
> some of it looking shiny--very uneven. I have sandblasted it and painted
it
> twice in two different ways with unsatisfactory results so far. I am
going
> to sand blast and try it again--only ONCE again--and it it screws up I
will
> sand blast it a 4th time and paint it SATIN BLACK!!!!!
>
> Hope you have better luck.
>
> ---David
|