| To: | spridgets@Autox.Team.Net |
|---|---|
| Subject: | Dumb Question Time |
| From: | LRuggi2635@aol.com |
| Date: | Sun, 3 Jan 1999 18:49:46 EST |
| Cc: | odernheimer@juno.com |
| Reply-to: | LRuggi2635@aol.com |
| Sender: | owner-spridgets@Autox.Team.Net |
Okay, this is the axle-ly challenged guy here AGAIN. I'll make it short and skip the embarrassing stuff: can one remachine/rethread the end of the axle case that holds the hub bearing assembly? Don't ask why I'm asking this question (LOL)-- suffice to say it has to do with "righty-tighty, lefty- loosy", NOT. Otherwise, the axle case is toast, I assume (thank goodness for spares...) Larry '65 Spridget '72 MGB |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | New/Used engine for my 1500cc Midget, William M. Gilroy |
|---|---|
| Next by Date: | Re: Xmas gift (MG baseball cap), Lancer7676 |
| Previous by Thread: | New/Used engine for my 1500cc Midget, William M. Gilroy |
| Next by Thread: | Re: Dumb Question Time-Rear Axle Threads, Grossac |
| Indexes: | [Date] [Thread] [Top] [All Lists] |