Hi Matt,
This is a ratio that was found in some early series II Morris cars with
the 803 OHV engine. It will fit a Spridget OK but what would you use
your car for then? Stump pulling?
Might be good for autocross though, then you could avoid first gear.
Paul Asgeirsson
Morriservice
9123 N Clarendon Ave
Portland OR 97203-2750
503-978-3998
PAsgeirsson@juno.com
On Tue, 10 Nov 1998 20:29:29 -0500 spriteguy@juno.com (Matthew P Johnson)
writes:
>I ran across an old differential carrier with 8-tooth pinion and
>43-tooth crown wheel (5.375:1). This sounds like a ratio found in a
>Morris Van. Does anyone know if this will fit in a Sprite MkIV axle
>housing?
>
>Any potential problems with using this in an autox car?
>
>Thanks.
>Matt
|