Well folks I need some suggestions;
I am in the beginning stages of refurbishment of a 1959 Bugeye bought it all
apart. Not a problem!.
But the first problem, went to attempt to remove the heat sensor from its
holder on the Radiator it had been cut off from the cable.
Well now I understand why it was cut off. Can not remove it. I tried
penetrating oil etc, then heat and you can then guess the solder joint gave
again (not a big problem just reattach), still can't get it out of the
holder unit ! Any suggestions and or does anyone have a spare holder unit
part to sell that the sensor unit screws into that I can resolder back on.
Regards,
Martin Cooper
Account Executive
Acuity Corporation
11100 Metric Blvd. Building #7
Austin, Texas 78758
www.acuity.com
888.242.8669 x 2242 Toll free
512.425.2242 Direct
512.719.8226 Fax
512.425.2277 Technical Support
mcooper@acuity.com
|