Or if you're into bicycling, the cone wrenches used for adjusting hubs are
quite thin.....
Not that I'd know from experience or anything..
Jim
> -----Original Message-----
> From: JustBrits@aol.com [SMTP:JustBrits@aol.com]
> Sent: Friday, July 17, 1998 6:54 PM
> To: spritenut@Exit109.com; cmlove@hiwaay.net
> Cc: spridgets@autox.team.net
> Subject: Re: ??Accelerator cable??
>
> In a message dated 98-07-17 18:37:39 EDT, spritenut@Exit109.com writes:
>
> <<
> It should be a 7/16" wrench not 1/2".
> I use a pair of needle nose pliers to hold one side and a thin 7/16
> wrench to undo the nut.
> It's tight but not too bad.
> >>
> I concur with Frank (as usual). A ''tappet adjusting wrench" [from
> Snap-On
> is what I have) is extra long and QUITE thin.
>
> Cheers...........
>
> Ed
|