Please tell me what it is!
I went through THREE cans of brake fluid trying to bleed the clutch on my
1275. I thought I finally got it all out, but the clutch engages about two
inches off the floor.
Tom Zuchowski
----------
> From: rickb@brodynet.com
> To: valntine@postoffice.ptd.net
> Cc: spridgets@Autox.Team.Net
> Subject: Re: Clutch release bearing
> Date: Thursday, June 25, 1998 7:02 PM
>
> Kevin,
>
> I just put my '74 Midget back on the road after major steel, paint,
> and engine work. I installed a roller bearing release bearing from
> MiniMania and it works very well. I also put in a teflon braided
> hose from Moss, and the combination feels very good. The worst part
> is getting the hydraulics bled again, but I found a technique that
> seems to work.
>
> Regards,
>
> Rick Brodeur
> '74 MG Midget daily driver (again)
> '61 Big Healey tri-carb (next project)
|