Hey guys!!!
I am looking for someone who is online right now who can give me some
information. I began my engine (1275 cc. Sprite MKIV) rebuild this
morning--used the plastiguage (green) on the mains. The front main checked out
at .002", the middle main at .003", and the rear main at .002". The mains
were checked dry--I wiped all oil from the surfaces, and torqued to 60 ft/lb.
These seem to be outside the spec clearances. Is there anyone there right now
who could e-mail me now to advise. Do I go on with the rebuild, or do I need
to get it looked at by a machinist? Would like to make headway this morning
of course.
Thanks to anyone and everyone who replies!!!
----David
|