| To: | Jim Henderson <jphender@inav.net> |
|---|---|
| Subject: | Re: Homebrew Eezibleed (long) |
| From: | Chuck Ciaffone <chuckc@ibm.net> |
| Date: | Sun, 11 Jan 1998 13:07:00 -0500 |
| Cc: | Patton Dickson <kpatton@worldnet.att.net>, Sprite List <spridgets@Autox.Team.Net> |
| References: | <34B84EB2.5D9C9EEE@worldnet.att.net> <34B85FF4.3771@inav.net> |
| Reply-to: | Chuck Ciaffone <chuckc@ibm.net> |
| Sender: | owner-spridgets@Autox.Team.Net |
I have not been following this thread, but if you are talking about a cap for the clutch master cylinder so you don't cannabalize the original, when I did mine, I found that the threaded plastic cap from a quart oil bottle worked great. And I was able to seal the needle (after roughing up the shank) into the cap to prevent air loss. Someone else found that the needle would fit the pre-drilled metal cap already on the MC. chuck -- ===================================================== chuck ciaffone chuckc@ibm.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: My promises...and a baby!, Larry Macy |
|---|---|
| Next by Date: | speed bleeders torque, Jeff Boatright |
| Previous by Thread: | Re: Homebrew Eezibleed (long), Jim Henderson |
| Next by Thread: | Re: Homebrew Eezibleed (long), Lancer7676 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |