Re: AAARRRGGGHHH! Haynes does it again!

[Dwgwater <Dwgwater@aol.com>]

In a message dated 97-12-11 12:09:42 EST, you write:

<< he #$%@ distributor came out of its
 clamp, so I have to start timing from scratch. >>

be careful reattaching the clamp.  I wasn't and cracked off a piece of the
distrib housing where the clamp attaches and had to get a whole new/used
distibutor.  The distib can also go in 180 deg out of phase (backwards so to
speak) so when you get the engine to TDC make sure the rotor is pointing at
the #1 cyl/wire.

been there etc.  no T shirt awarded