Hi George,
The bracket is right behind the hole, but it is cast iron and fairly deep. If
I was good enough, I could probably drill a hole in the bracket and tap it for
the screw, but I don't trust that I would get it lined up well enough.
There is some space right beind the screw hole to allow the screw to poke
through. I am thinking of enlarging that space so I can get a nut in there.
Thanks,
Roger
-----Original Message-----
>From: George Parker <george.parker2012@comcast.net>
>Sent: Dec 17, 2012 1:05 PM
>To: spitfires@autox.team.net
>Subject: Re: [Spits] Top Timing cover Screw
>
>I'm trying to remember the configuration here...B But if I recall correctly,
>the mounting bracket in question mounts right behind the stripped out screw
>hole??B CanB one long bolt be put through the timing cover, front plate
>(where the threads are stripped) and the mounting bracket?B Just a thought...
>
>
>v/r,
>
>George P.
>_______________________________________________
>
>Spitfires@autox.team.net
>Donate: http://www.team.net/donate.html
>Suggested annual donation $11.47
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/spitfires/elliottr@rmi.net
_______________________________________________
Spitfires@autox.team.net
Archive: http://www.team.net/archive
|