You don't it with a gasket, you use it instead of a gasket.
Hylomar doesn't dry and stick. Using it with a gasket results in the gasket
not being held in place, and the gasket much more easily can be blown out.
>From the technical data sheet:
"Hylomar Universal Blue should be applied to clean dry surfaces. Apply a thin
film or bead to one or
both surfaces. Once applied, sufficient time should be allowed for the solvent
to evaporate. Unlimited
assembly time allows precise alignment of joints to be made. Due to the nature
of the compound,
fasteners may be required to be re-tightened to the correct torque."
http://www.hylomar-usa.com/_resources/_pdf/Hylomar_Univ_Data.pdf
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|